Beneteau Oceanis Clipper 343

Electronics

Cd player, Wind speed and direction, Depthsounder, Cockpit speakers, Gps, Log speedometer, Plotter, Vhf, Tv set, Radio, Compass

Electricity/ Motor Beneteau Oceanis Clipper 343

Shore power inlet

Deck equipment

Steering wheel, Lazy bag, Solar panel, Cockpit shower, Spray hood, Lazyjacks, Swimming ladder, Teak cockpit, Cockpit table

Comfort / Interior

Battery charger, Marine head, Refrigerator, Oven, Manual bilge pump, Heating, Hot water, Electric bilge pump

Sail

Mast:
Fractional 9/10 tapered mast in anodised aluminium. Deck-stepped with stainless steel pillar in the bar. Aft swept 20° pair spreaders. Boom topping lift on a cleat on the mast. Boom: Anodised aluminium. Two “automatic” reefing lines led stern to cockpit.
Boom tailored with mainsail outhaul tackle. Rigid boom vang led stern to cockpit. 
Standing Rigging
Discontinuous stainless steel wire rigging (1 x 19) Original. Forestay with hand-operated genoa furling gear. 2 sternstays. 2 aft inner shrouds and 2 cap shrouds on side deck. Shroud chainplates on side deck allow for closer sheeting of jib. 
Running Rigging
Low-stretch genoa and mainsail halyards. Boom topping lift. Two genoa sheets. Mainsail sheet with pulley unit. Rigid boom vang led stern to cockpit. Genoa furler line.A-sail spinnaker gear.  
Sails 
Mainsail by Elvestrom 2007 
Genoa Furling by Elvestrom 2007 
Cruising Chute and Snuffer 
All Sails fully serviced and laundered by Owen Sails 

I : 43.44 ft
J : 12.80 ft
P : 39.14 ft
E : 13.58 ft
Working Sail Area : 649.06 sq ft

Furling genoa, Battened mainsail

Manufacturer Provided Description

This body crafted by the Berret/Racoupeau tandem, has adopted space, beam, all weather, all velocity performances and great inside luxury.Offered with two different chairing versions, for 2 couples or for a team of up to eight.
Celebration package;  
8 desk settings, 800w electric gustless, additional opening hatch aft compartment, H&C cockpit shower, spray hood.

Construction

The body is single-skinned GRP development. Reinforced points (keel, rudder, chain plates, body-deck joint) help to strengthen the structure.
A structural inner moulding is bonded and laminated to the body. Its structural role is imseaportant as it takes and absorbs the stresses at pressure points (shroud chain-plate tie rods, keel, rudder, etc.), and spreads any loads guaranteeing reduced strain on the body.
The surface material of the inner moulding makes cleaning easier and provides a better finish.
The stainless steel propeller shaft is mounted and protected in a GRP skeg.
The basic body colour is white with blue and silver livery. Steel Blue is available as an option.
The deck is sandwich development (glass fibre and balsa) for an optimal strength/weight ratio and thermal and sound insulation.
A diamond point non-slip surface increases safety over all areas of movement on deck.
Cockpit 
Central pivoting helm chair for ease of access to bathing floor. 2 teak slatted helm chairs on each side of the cockpit, plenty of storage space to make life on board easy:
2 side cockpit safes, (liferaft in starboard safe),1 starboard aft cockpit safe, 1 apart watertight gasoline safe to seaport. Teak slatted cockpit benches.
Leather-covered pivoting stainless steel direction wheel on column, on the column: 1 direction compass, engine control lever, supseaport for direction instruments, handrail, glass holder.
Teak cockpit desk with folding leaves.
Engine control panel manufactured into chairing to seaport.
Manual bilge pump in cockpit.
 

Mechanicals

Yanmar 3YM30 Diesel Engine with 3 cylinders and 27Hp.Last assistanced 2022 
Engine mounting manufactured into the inner moulded engine compartment soundproofed with insulating foam.
Engine control panel (rev. counter and alarms) with engine control lever in seaport cockpit.
Stainless steel propeller shaft is protected in a GRP skeg moulded with the body, three- or two-blade fixed propeller according to engine.
Rotomoulded 75 L fuel basin with electric gauge.
Water filter to cooling unit.
Electrics 
9-switch 12 V electrical panel with voltmeter.
Toggle circuit breaker 12 V socket on panel.
2 x 70 Amp assistance charger and by one 70 Amp engine charger. all replaced 2022
Coupling relay.
Alternator potential: 14 V / 60 A. 
Newly installed Solar Panels and charging unit.
Invertor
Voltmeter.
Electric fuel gauge.
220 V sand supply and charger.
220 V sockets situated in the compartments, bar and galley.
Navigation beams
Fore and aft direction beams.
Steaming beam.
Anchor beam.
Wiring for deck searchbeam.
Lights
In the 2-compartment version, there are 4 reading beams, 2 halogen strip beams and 11 deckfront beams.
Water System 
Electric new water pump with filters and accumulator.
All seacocks are tailored with ¼ turn valves.
Electric sump pump for emptying shower.
One hand-operated and one electric bilge pump.
Fresh water
The pressurised new water unit comprises two rotomoulded basins, 160 L forward and 95 L in the bar. A filter protects the unit.
Hot water
Hot water as basic is provided by a 25 L calorifier operated by a heat exchanger or by 220V sand supply.
Hot and Cold water shower to bathing floor.
Tankage 
1x Diesel basin 75 Litres 
2x Water basins 225 Litres 
1x Holding basin 80 litres 

Accommodation

Woodwork is in fruit-tree coloured wood. Varnished "hydropont" sole with black inlay strips.
5 Outlet Eberspacher Air b