Gianetti Navetta 19

Full Specs

PRINCIPAL CHARACTERISTICS
Builder: GIANETTI YACHT (Italy)
Model: GIANETTI NAVETTA 19
Hull: Fibreglass - White
Superstructure: Fibreglass - White
Type: Motor-Yacht / Semi-displacement / Flybridge
Model year: 2012
Beam: 5.20 m
Draft: 1.50 m
Fuel basin: 5,000 l
Water basin: 1,000 l
Engines: 2 x CAT 575 HP (420 hrs Nov 2013)
Cruising velocity: 11 Knots
Maximum velocity: 16 Knots
Displacement light: 26 Tons
Generators: 2 x NORTHERN LIGHTS 16 kW
Stabilizers: Yes, fin - water potential
Cabins: 3 (1 Master, 1 VIP, 1 Twin)
Bathrooms: 3
Crew compartment: 1 For 2 members, 1 powder room
Lying: Holland
 
STANDARD EQUIPMENT
Hull and Deck Structure:
The vessel is certified CE-A
The body will is reinforced fibreglass polyester isoftalic of the best condition.
In order to avoid osmosis problems the first two layers of fibreglass will be done with vinylester resin (resin completely waterproof).
The body is also reinforced interior by means of a grid of longitudinal and transversal reinforce called girders and frames. These structures will be pre-owned also for the development of the structural basins of new water, grey waters and sewage waters improving the strengthness of the body.
The deck and the hard top will be done in reinforced fiberglass with core foam (sandwich). The sandwich gives rigidity to the surface of the deck without improving its weight and in addition gives a good insulation against the noise, heat and condensation.
 
Deck Covering:
The cockpit and the aft floor are covered with solid teak wood 12 mm thick.
 
Engine Room Insulation:
The insulation is made with two lay of high density rock wool with interposed a sheet of lead 6/10 mm, in order to have the best insulation against heat and noise.
 
Security and Fire Fighting Equipment:
All the machinery is installed according to the rules of Rina Naval Register.
1 x Centrifugal electric pump for either bilge and fire fighting assistance (chain washer also)
1 x Emergency bilge hand pump
2 x Emergency bilge suction by means of the engine sea water pumps
Piping in copper
4 x Submersible bilge pumps with automated floating switch and high water level alarm transmitted on the captain house console (one each watertight compartment)
6 x Powder fire fighting handle bottle
Fixed CO2 plant with shut off unit for air ventilation and gasoline
 
Gangway:
Predisposal for subsequent installation of retractable gangway
 
Deck Equipment:
Electric windlass 2000 W, LOFRANS with pubbotin for a 100 Mt chain 12 mm
1 x Capstan 1000 W on the cockpit
1 x Swim ladder
Teak cockpit, sides (up to amidships), and swim floor
 
Steering Plant:
2 x suspended rudders in the propeller flow
Electro-water potential servo assisted direction pump mod. BCS
Autocaptain
Steering wheel on the captain console
Emergency pub
 
Piping in copper
Hydraulic cylinder in the lazzerete
Portholes, Windows and Door
14 x Oval portholes in stainless steel and safety glass
2 x Fixed large windows located in the proprietor compartments, drawing to be supplied later
Windows in safety glass with two sliding windows on the sides
Rear saloon door in four, two of them in the middle to be opened sliding
 
Fresh Water System:
Structural fiberglass basin for 1,100 l
Fresh water inlet located on the aft of the vessel
2 x Fresh water pumps, (only 1 working the other one is for spare)
Piping in PVC and aluminum
1 x Water heater 80 Lt
 
Toilet System:
Each toilet model SANINAUTICO is totally independent from the others and very silent
A structural sewage basin is tailored on the bottom of the body, proprietor has the possibility to send the exhaust water to the basin or directly to the sea. To pump out the basin a “black water pump” is tailored, it is possible to pump out the basin directly to the sea or to the pier
The toilet can be pre-owned either with sea water or new water
 
A