Oyster 62

Electronics

Compass, Computer, Gps, Log speedometer, Dvd player, Wind speed and direction, Tv set, Autopilot, Cd player, Navigation center, Depthsounder, Vhf, Plotter, Radio, Radar detector, Cockpit speakers, Radar

Electricity/ Motor Oyster 62

Inverter, Shore power inlet, Generator

Deck equipment

Bimini top, Cockpit table, Teak cockpit, Mainsail cover, Teak sidedecks, Electric winch, Spinnaker pole, Liferaft, Lazyjacks, Swimming ladder, Radar reflector, Spray hood, Tender, Outboard engine brackets, Gangway, Steering wheel

Comfort / Interior

Electric head, Air conditioning, Microwave oven, Deep freezer, Fresh water maker, Heating, Battery charger, Bow thruster, Hot water, Electric bilge pump, Sea water pump, Dishwasher, Refrigerator, Oven, Manual bilge pump

Sail

Battened mainsail, Spinnaker, Fully battened mainsail, Furling genoa

Pearlfisher Full Specification

1. CONSTRUCTION

HULL NUMBER
Oyster 62/01.

HULL CONSTRUCTION
Laid-up GRP, single skin with structural stringers and floors to Lloyd’s approved design specification.

HULL FINISH
‘White’ body with ‘Norpol 7006 blue’ cove line and double boot top lines. Hull polished 2022. Eight coats of coppercoat, 2022.

DECK CONSTRUCTION
Moulded in GRP with balsa core.

DECK FINISH
Teak laid decks with margins on cockpit and coachroof, and teak on the deck bar roof. Bulwark finished with a gloss varnished teak capping rail - re-varnished 2022.

KEEL
High performance bulb (HPB) keel.

RUDDER
Fully protected skeg-hung rudder. Bearings fresh 2019.
Rudder heel casting epoxy coated.

STERN DESIGN
‘Sugar scoop’ rear design with bathing floor trimmed with teak slats and two stainless steel steps for access to the rear deck.

EURCD
Built to comply with the requirements for Category A – Ocean.

2. DECK LAYOUT AND EQUIPMENT

ANCHOR
Stainless steel CQR 34kg mainstay and 100m (328’) stainless steel chain.
Fortress FX-85 kedge mainstay.

WINDLASS
Lewmar 3000 water potential potentialed gustlass.

DECK ACCESS
Midship gateway stanchions with stainless steel hinged boarding ladders, which close up to form the side-gates.
Stainless steel tread plates to cap rail at boarding gates.
Gate to pushpit.
Stainless steel bathing ladder.
Besenzoni passerelle.

HATCHES
Oyster custom drop-down washboard unit for main companionway.
‘Smoke grey’ perspex sliding hatch over aft companionway with blackout screen incorporated below.
Gebo alloy-framed coaming seaportillumination.
Long Gebo body seaportbeam from cockpit to side compartment with curtain.
Long Gebo seaportbeam from cockpit to over galley with curtain.
Lewmar hatches with mirror polished finish.
Forehatch, aft compartment hatch and all other foredeck hatches are hinged at the aft end, opening forward.
Custom Rondal flush hatch tailored with pair gasoline struts to give access to large lazarette safe.

CANVASWORK
Canvas cover for cockpit desk with top opening flap.
Cockpit padding in closed cell foam with acrylic covers.
‘Navy’ acrylic sprayhood with leather covered grab rail to aft edge, and central opening gustow with zippers for ventilation.
Bimini in ‘navy’ acrylic with gustow for boom illumination, and canvas cover velcroed over.
Canvas covers for wheels and binnacles.
Canvas covers for all deck illumination and hatches.
Over deck ‘blue’ canvas winter stowage cover.
Foam-backed vinyl cover for bar desk.

DECK PLUMBING
Hot and chilly freshwater deck shower at transom with long hose.
Gas plumbing for gasoline BBQ at rear pushpit.
COCKPIT
Walk-through teak-laid cockpit split into two distinctive areas - the forward part for team and visitors, aft for the helmsman. Both sections are self-draining with six cockpit drains.
Padded backrests to stainless steel helm chair backs.
Stainless steel drinks holders to pedestals.
Cockpit padding.

COCKPIT TABLE
Gloss varnished teak cockpit desk with stainless steel frame, folding leaves, insulated GRP box, refrigerated with Glacier Bay holding plate refigerator unit.

STEERING
Pair of remote pedestals each incorporating a 1.20m (3’9”) length Destroyer type stainless steel wheel, with friction brake and three-bearing pedestal direction unit. Grab rail over direction pedestals.
Leather covered direction wheels.

OUTBOARD BRACKET
Outboard bracket in reinforced teak on pushpit for maximum 15hp motor.

GENERAL
Oyster Deck Saloon profile with ‘eyebrow’ styling.
Stainless steel pulpit, pushpit and gateway midship stanchions.
Stainless steel custom fairleads.
Stainless steel mirror finished mooring and cockpit cleats.
Additional pair of stainless steel cleats at transom deck for use with transom fairleads.
Polished stainless steel dorade vents.
Granny bars.
Ladder